Gate services, North Richland Hills, TX
Electric Gate Repair in North Richland Hills, TX
Electric gate trouble usually traces to wiring, controllers, or motor issues. We find the root cause and restore reliable operation.
When an electric gate goes completely dead, the fault is usually upstream of the operator. We start at the power source and work in: the breaker, the transformer, the low voltage run out to the gate, the battery, and then the control board. Buried wire runs are a frequent culprit, because a nick in the insulation from the original install takes years to corrode through and then fails on a wet week.
Surge damage is the other big one in this area. A storm puts a spike through the house and the gate control board is often the first thing to die, since it sits at the end of a long wire run that acts like an antenna. Boards that fail this way usually show scorching around the input side.
We test rather than guess. Swapping a board into a system with an underlying wiring fault just kills the new board too, and a LiftMaster or DoorKing board is not a cheap part to burn up twice. So we confirm the supply and the runs are clean before anything gets installed. It takes an extra half hour and it has saved more than one customer from paying for the same board in April and again in May.
Signs you need electric gate repair
- The gate is completely unresponsive with no lights on the board
- It worked until the last thunderstorm
- The keypad or call box lights up but the gate does not move
- The system runs briefly then drops out, especially after rain
- You can smell burnt electronics at the control box
What to expect when we show up
- Quick scheduling, often same-day in North Richland Hills, TX
- Real diagnosis with a clear quote before any work starts
- Quality parts and proper installation, every time
- Friendly crew who treats your home like our own
Frequently asked questions
My gate died after a storm. Is the board gone?
Frequently, yes. Surge damage to gate control boards is common here because the long low voltage run out to the gate picks up spikes. We check the supply and the wiring first, though, because installing a new board into a faulted system just destroys the new board too.
Can a bad wire run cause intermittent problems?
Yes, and it is one of the more frustrating faults to live with. A nicked buried wire will work fine when the ground is dry and drop out when it is wet, which makes the gate seem possessed. Those need locating rather than guessing at.
Should I add surge protection?
Worth it. A surge protector at the gate is inexpensive compared to a control board, and board failures after storms are one of the more common gate calls we take. It is also the kind of thing nobody thinks about until after the first one dies.
Related services
Sliding Gate Repair
Sliding gates rely on smooth tracks and aligned rollers. We repair tracks, replace rollers, and tune the operator for clean, quiet travel.
Learn moreSwing Gate Repair
Swing gates need balanced hinges, healthy hydraulics or rams, and proper alignment. We service all of it, including weld repair on bent or cracked frames.
Learn moreGate Motor Replacement
A burned-out gate motor doesn't mean a whole new system. We'll match what you've got, save you the parts you already paid for, and only suggest an upgrade if it'll actually save you money down the road.
Learn moreGate Circuit Board Replacement
If your gate has gone unresponsive after a storm or just quit out of nowhere, the brain inside it is usually the culprit. We swap the board, get your remotes and keypad talking to it again, and have you back to normal the same afternoon.
Learn moreSame-day service when we can swing it
North Richland Hills, Keller, Hurst, Bedford, Watauga, Colleyville, Southlake.
(817) 789-7039